VR Tourviewer Forum

VR Tourviewer Board => Support / General Discussion => Topic started by: jrsmith on June 21, 2019, 12:19:17

Title: Default View not used after upgrade to 1.1.243
Post by: jrsmith on June 21, 2019, 12:19:17
Hello,

After updating VR Tourviewer on Oculus Go to version 1.1.243 panorama images do not load to the default view.

This affects the starting position of the first node, and any node where I am happy with the default view so have not set a target view. When setting the default view I have right clicked the image in Pano2VR and selected "Set Default View".

Where I have set target view on a node (say when travelling back in the opposite direction to the default view) this node still loads pointing in the correct target direction.

I'll upload the tour and send you the link.

Kind regards,
Jonathan
Title: Re: Default View not used after upgrade to 1.1.243
Post by: Ruud van Reenen on June 21, 2019, 12:30:17
Hi Jonathan,

Thanks for reporting, tested and can confirm the issue.
I'll fix this today and publish the update.
Title: Re: Default View not used after upgrade to 1.1.243
Post by: Ruud van Reenen on June 21, 2019, 14:09:22
Fixed and released the updates for Oculus Go, Quest and Rift, 1.1 build 244.

This issue only occurred on the VR apps for build 1.1.243. The Remote version 1.1 build 243 was not affected so won't need an update.

Thanks again for reporting!